The introduction of the water well mold is mostly made of thick steel plate, which has a closure. The size and specification are also various. It can be customized according to the needs of customers, most of which are about 70 cm. The reason why the steel template is used is that the surface of the steel is smooth, hard, solid and reliable, and it can be kept stable during the operation process, with excellent material and disassembly Simple. The scope of use of the down well mould includes drainage and water supply, power cable maintenance, communication, natural gas pipeline, etc., which facilitates the life of the residents, the maintenance of the workers, and the service to more industries in the future. It is one of the products worthy of promotion by our manufacturers. The rationality should be considered in the design of the inspection well mould. If there is no reinforced structure, the mould is easy to pile up at the mouth when discharging, which will increase the load borne by the mould and cause the possibility of deformation. The materials used need to be refined and extracted to ensure the use quality.
The lower well mold is mainly divided into two parts. In actual use, it needs to be selected according to the construction drawings and construction requirements. Generally, the internal mold and the external mold are used in one set. If there is a requirement for the wall thickness of the sewage well, the size and model of the internal mold and the external mold can be adjusted. The internal mold is composed of three large steel plates, but these three steel plates are not the same size. One of the steel plates presents an inverted cone, which is the same as a triangle. This design is to facilitate the removal of the mold. During production, it is necessary to pour mud into the sewage well mold to solidify and form. The whole internal mold will be squeezed naturally at the inner side, It will be more difficult to remove the mold, and the design of the three templates helps to remove the mold and reduce the probability of mold damage. The outer mold is a common two-piece mold, there is no other unique design, but the outer side of the sewage well mold is welded with rib plate to enhance the pressure resistance effect of the mold. When using, it is necessary to ensure the placement position of the mold, and there should be no unstable problem. After that, it is necessary to brush the internal mold with release agent, and then brush the external mold, and then it can be used after being sleeved together. Then such sewage well mold can be used normally.